Current Price: $145.0

Description WILL SHIP OUT THE SAME
BUY IT NOW
LAST ONE IN STOCK
You'rebuying abrand newSeioMulti controller Intended for use with only SEIO water pump models: 1100, 1500, & 2600 The controller will control one or two SEIO Super Flow Water Pumps. The pumps can be set to go from low to high; this surge can be set from 15 seconds to 30 minutes. The pumps on low operate at approximately 50% flow and then will ramp up to 100% when on high. There are also two preset feeding buttons at 8 minutes and 16 minutes. Once the time has elapsed the unit will go back to the original preset. Note: Replaceable fuse 2.5 amp/250v
IMPORTANT INSTALLATION SAFEGUARDS AND SAFETY GUIDELINES: Do not operate the SEIO controller with any other type of pump. Mount controller where it will not come in contact with moisture or water. Mount the controller securely above the aquarium. Prior to maintenance on any electrical aquarium appliance or maintenance to the aquarium, you must disconnect all electrical aquarium devices. Routine maintenance is required to ensure the maximum performance and the longevity of the controller and SEIO water pumps. See maintenance guidelines in SEIO water pump instructions. The use of a surge suppressor is strongly recommended. A drip loop must be used when plugging all electrical aquarium devices. The drip loop is that part of the cord which hangs below the level of the receptacle. You must verify that the receptacle is clean and free of moisture at all times. The receptacle must be free of water, salt and calcium. Do not deviate from the Safeguards and Safety Guidelines The national code requires that a GFCI be utilized in the branch circuit which supplies electrical power to the aquarium pump and all other electrical aquarium devices. Clean the controller as needed to keep unit free of dust and al deposits
INSTALLATION Find a dry area to mount the controller. Secure the controller above the aquarium/water level. Area must be well ventilated. Never place controller under or inside the aquarium cabinet. Plug one or two pumps directly into the controller. While the unit is off, plug the controller into a GFCI electrical receptacle. Turn the controller ON. The screen will now read 15 and the yellow second LED will be lit. Press the set button until the desired time parameter is set. The yellow LED is for seconds and the red LED is for minutes. Once the desired time is set, press the auto button. Once set, the time screen will switch off. When feeding, press the auto button then press the desired feeding time.
SHIP THE SAME DAY and its FREE !!!
SHIPPINGto Alaska and Hawaii will cost $18.

');
document.write('');
document.write('');
//--> Powered by eBay Turbo Lister

Click Here for More Information about the New SEIO multi controller pump SALE